Procomm plus for windows 10 upgrade#
Procomm plus for windows 10 software#

Select new name under 'Modem-Setup' New, enter your Zypcom model number andД¬lick on OK. From this dialog box, click on 'Modem Setup' and change the init Middle of the toolbar), select 'Connection', and then click on 'Advanced' on Go into setup icon (the one with the monitor, folder and three colors in the From this dialog box, click on 'Port' and change the port. Go into setup icon (the one with the monitor, folder and three colors in the middle of the toolbar), select 'Connection', and then click on 'Advanced' on the menubar.

Procomm plus for windows 10 upgrade#

NOTE: If you have Procomm Plus v2.0 for DOS (NOT v2.01 - you can check by hitting Alt-I from terminal mode), then you should upgrade to v2.01 since the original v2.0 had a 16550 UART utilization problem. In Result Messages under Modem Options, make sure all of the connection messages read 'CONNECT' instead of 'CONNECT^M' for 300, 'CONNECT 1200' for 1200, etc. In Modem Options, choose General Options and make sure Autobaud Detect is OFF.

Procomm plus for windows 10 software#

Go into the Setup screens (Alt-S), make sure in Terminal Options, software (XON/XOFF) flow control is disabled, and hardware (RTS/CTS) flow control is enabled. Set your port speed at 38400 via Alt-P from terminal mode. Change init string to 'AT&F&C1&D2S0=0W2^M'. Go into setup via 'ALT-S', and then into 'MODEM SETUP'. We would recommend using hardware flow control, Class 1, and 14400 maximum transmit and receive rates with the initialization string of 'AT&F&C1&D2W2S0=0^M'. Obviously, the fax initialization string will have to match the options chosen. You can change many settings from this screen, including the Port, Flow control, Fax Class, maximum transmit and receive rates, and initialization string. At the top of the dialog box, it will let you select between 'Off', 'Data' and 'Fax' and the number of rings.ДЇor fax setup, you will have to click on the 'Fax Connection' button on the left hand side of the screen.

You can change how the modem answers by clicking on the 'Answer Options' on the left hand side of the 'Current Setup' dialog box. Make sure that the 'Command Suffix' is set to '^M'.ДЇrom the 'Connect Messages' dialog box, make sure that 'Auto Baud Detect' is not checked, and the locked baud connect message is 'CONNECT'. The init string should be 'AT&F&C1&D2W2S0=0^M'. Make sure that the two checkboxes on this screen, 'Use DTR to hang up' and 'Use hardware flow control' are checked.Д¬lick on the 'Data Modem Commands' button (still within Data/Modem Connection dialog), and click on the 'Advanced' button. You can also change your port speed on this screen. Under 'Selected Port', you can change your COM port. There are a number of buttons on the left hand side of the screen which change the current dialog box.Д¬lick on the 'Data/Modem Connection' button on the left hand side, and make sure that 'Connection Setup' button has been selected (it's near the middle of the dialog box). This will bring you to the 'Current Setup' dialog box. To go to the setup section after installation, click on the button that has the rainbow, screwdriver and monitor on it (it's on the toolbar, near the middle of the screen).